Allow your filler of patching plaster to fully cure as stated by the manufacturers guidelines and then sand it back so that it is smooth and level with any surrounding surfaces. In this example here we are using an existing lighting circuit so a 1mm twin and earth cable is run out from the top of the ceiling rose, down through the ceiling and down a chase that was cut into the wall. Dual Voltage shaver sockets (such as the one in the above image) are also available and have the advantage that they can be used for 240 volt or 110/115 volt appliances. Note: The particular wiring setup in your home may differ from the above, but your electrician will know the best route to take. One point to note is that when installing an FCU, you will need to run from the supply to the FCU and then from the FCU to the shaver socket.

UK 2 to 3 Pin Adaptor Plug For Shavers And Toothbrushes

Despite this, batteries need to be recharged somehow and with the increasing popularity in battery-powered toothbrushes that can also use a shaver socket, they have made a bit of a come back and not just in the bathroom as they can be located anywhere in the home, more commonly in bedrooms.Some of our partners may process your data as a part of their legitimate business interest without asking for consent.

Fitting an Electrical Shaver Socket | DIY Doctor

If it's a permanent arrangement have you thought about changing the european plugs for 3 pin 13A plugs? When choosing a shaver socket for a bathroom as mentioned, look for the British Standard BS3535 as this will confirm it is safe to use. This is a necessary step as once the cable is filled over it’s a nightmare to have to dig it all out if it’s damaged.A “chase” ( see out project on cutting chases here for more information) is cut down into the wall in a straight vertical line down to the location of the shaver socket. This easy to use design is supplied with 7 jack plug adaptors to suit a variety of socket types and is perfect for travelling abroad. The fused connection unit or FCU features a replaceable fuse that, in the event of any issues will blow and cut power to the shaver socket. Providing the Shaver socket is reduced to 110V it should go in zone 2 or preferably, zone 3, never in zone 1. If no supplies are this conveniently placed then it may be that you have to take up some floorboards in an above room and run your supply from here.